城市生活垃圾和污水处理厂剩余污泥混合发酵的原料配比优化研究

以城市生活垃圾和污水处理厂的剩余污泥为混合原料,研究了混合原料的不同配比对厌氧发酵过程及产气的影响。结果表明:城市生活垃圾与剩余污泥以挥发性固体(VS)质量比为2∶1混合后,厌氧发酵效果最好,累计产气量最高,达到8 721mL,发酵后的总固体(TS)、VS、COD去除率分别达43.65%、35.98%、47.88%;各实验组在发酵过程中的pH、氨氮浓度和碱度均在合理范围内,未对厌氧发酵反应造成影响;以适当配比的城市生活垃圾和剩余污泥为混合原料,进行中温联合厌氧发酵是可行的,联合厌氧发酵可以弥补单一原料的缺陷,在一定程度上改善厌氧发酵效果。     

Source Type Evaluation of Polycyclic Aromatic Hydrocarbons (PAHs) in Surface Sediments from the Muar River and Pulau Merambong,Peninsular Malaysia

This article is the most recent report of polycyclic aromatic hydrocarbons (PAHs) in the Muar River and Pulau Merambong, Peninsular Malaysia. A total of 16 priority pollutant PAHs in addition to methylphenanthrene among alkylated PAHs were analyzed in surface sediments during May 2013. Total PAHs ranged from 212 to 440 and 151 to 412 ng g^?1 dw in sediments from the Muar River and the Pulau Merambong, respectively. The Muar River showed an increasing trend of PAH concentrations, while no previous data exist for the Pulau Merambong. Generally, mixed petrogenic and pyrogenic sources of PAHs with predominance of the latter were detected in the study area. Effective management of oil pollution has caused a drastic decrease in petrogenic sources of PAHs.     

活性滤料滤池气提系统影响因素研究

为了研究气量、水深和提砂管规格对活性滤料滤池提砂系统性能的影响,本实验以石英砂作为活性滤料滤池的提升介质,在恒定水头状态下,测量了不同管径下被提升的水和砂的体积和质量随压缩空气流量的变化.结果表明:随着气量的增大,提升系统的提砂量和提砂效率均呈先增大后减小的趋势;提砂管管径是最大提砂量的限制因素,但提升的砂水体积比与管径无关;相同气量条件下,单位空气提砂量与水深呈线性关系.因此,在活性滤料滤池提砂系统的设计应用过程中应选择合适的提砂管径,尽量增加浸水率,并注意控制气量以提升系统能效.     

Effect of a high strength chemical industry wastewater on microbial community dynamics and mesophilic methane generation

A high strength chemical industry wastewater was assessed for its impact on anaerobic microbial com- munity dynamics and consequently mesophilic methane generation. Cumulative methane production was 251 mL/g total chemical oxygen demand removed at standard temperature and pressure at the end of 30 days experimental period with a highest recorded methane percentage of 80.6% of total biogas volume. Volatile fatty acids （VFAs） analysis revealed that acetic acid was the major intermediate VFAs produced with propionic acid accumulating over the experimental period. Quantitative analysis of microbial communities in the test and control groups with quantitative real time polymerase chain reaction highlighted that in the test group, Eubacteria （96.3%） was dominant in comparison with methanogens （3.7%）. The latter were dominated by Methanomicrobiales and Methanobacteriales while in test groups increased over the experimental period, reaching a maximum on day 30. Denaturing gradient gel electrophoresis profile was performed, targeting the 16S rRNA gene of Eubacteria and Archaea, with the DNA samples extracted at 3 different time points from the test groups. A phylogenetic tree was constructed for the sequences using the neighborhood joining method. The analysis revealed that the presence of organisms resembling Syntrophomonadaceae could have contributed to increased production of acetic and propionic acid intermediates while decrease of organisms resembling Pelotomaculum sp. could have most likely contributed to accumulation of propionic acid. This study suggested that the degradation of organic components within the high strength industrial wastewater is closely linked with the activity of certain niche microbial communities within eubacteria and methanogens.     

Quantitative method to determine the regional drinking water odorant regulation goals based on odor sensitivity distribution：Illustrated using 2-MIB

Taste and odor （T/O） in drinking water often cause consumer complaints and are thus regulated in many countries. However, people in different regions may exhibit different sensitivities toward WO. This study proposed a method to determine the regional drinking water odorant regulation goals （ORGs） based on the odor sensitivity distribution of the local population. The distribution of odor sensitivity to 2-methylisobomeol （2-MIB） by the local population in Beijing, China was revealed by using a normal distribution function/model to describe the odor complaint response to a 2-MIB episode in 2005, and a 2-MIB concentration of 12.9 ng/L and FPA （flavor profile analysis） intensity of 2.5 was found to be the critical point to cause odor complaints. Thus the Beijing ORG for 2-MIB was determined to be 12.9 ng/L. Based on the assumption that the local FPA panel can represent the local population in terms of sensitivity to odor, and that the critical FPA intensity causing odor complaints was 2.5, this study tried to determine the ORGs for seven other cities of China by performing FPA tests using an FPA panel from the corresponding city. ORG values between 12.9 and 31.6 ng/L were determined, showing that a unified ORG may not be suitable for drinking water odor regulations. This study presents a novel approach for setting drinking water odor regulations.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

宜昌市三级监测站标准化建设现状分析及对策研究

标准化站建设是提升环境监测站能力水平的重要途径和抓手,为促进宜昌市三级站的整体达标验收,该研究分析了辖区三级监测站标准化建设存在的主要共性问题为：在岗人员数量少和人才流失严重、经费保障和监测用房面积不足、监测项目偏少、管理体系不健全,并结合实际提出了加强人才队伍建设、拓宽监测经费来源、提高监测分析能力和强化质量管理等对策建议.     

废旧线路板回收的污染防治技术综述

废旧线路板回收不仅能够解决电子废弃物迅速增长带来的环境污染问题,而且可以实现资源再生利用,是中国当前鼓励发展的行业。线路板回收过程也将不可避免的带来一定环境污染问题。中国企业现阶段常用的线路板回收工艺主要包括机械物理法、湿法冶金、火法冶金、热解法等。废旧线路板的回收工艺不同,污染物产生特点也不同,企业应根据线路板回收工艺有针对性的选择污染防治措施。线路板回收过程中产生的废渣再利用应成为今后研究的重点。     

Effect of lubricant sulfur on the morphology and elemental composition of diesel exhaust particles

This work investigates the effects of lubricant sulfur contents on the morphology, nanostructure, size distribution and elemental composition of diesel exhaust particle on a light-duty diesel engine. Three kinds of lubricant (LS-oil, MS-oil and HS-oil, all of which have different sulfur contents: 0.182%, 0.583% and 1.06%, respectively) were used in this study. The morphologies and nanostructures of exhaust particles were analyzed using high-resolution transmission electron microscopy (TEM). Size distributions of primary particles were determined through advanced image-processing software. Elemental compositions of exhaust particles were obtained through X-ray energy dispersive spectroscopy (EDS). Results show that as lubricant sulfur contents increase, the macroscopic structure of diesel exhaust particles turn from chain-like to a more complex agglomerate. The inner cores of the core-shell structure belonging to these primary particles change little; the shell thickness decreases, and the spacing of carbon layer gradually descends, and amorphous materials that attached onto outer carbon layer of primary particles increase. Size distributions of primary particles present a unimodal and normal distribution, and higher sulfur contents lead to larger size primary particles. The sulfur content in lubricants directly affects the chemical composition in the particles. The content of C (carbon) decreases as sulfur increases in the lubricants, while the contents of O (oxygen), S (sulfur) and trace elements (including S, Si (silicon), Fe (ferrum), P (phosphorus), Ca (calcium), Zn (zinc), Mg (magnesium), Cl (chlorine) and Ni (nickel)) all increase in particles.     

基于生态系统供给及净化服务功能的贵州省水生态占用研究

针对传统及现有水生态足迹理论及其模型存在的缺陷与不足,本文提出了基于生态系统供给及净化服务功能的贵州省水生态占用概念与模型,将其划分为生物生产和非生物生产的水生态占用两部分,建立水产品、水资源、水环境3类账户,并在此基础上以2000—2014年的贵州省为例进行计算分析,结果表明:(1)水产品账户中,贵州省水产品消费的水生态占用总体呈上升趋势,水生态承载力波动变化较小,水产品消费呈生态赤字状态,且其生态压力较大;(2)水资源账户中,贵州省淡水资源的水生态占用整体呈逐渐上升趋势,水生态承载力则呈明显波动的趋势,且变化幅度较大,淡水资源消费处于生态盈余状态,且其与水生态承载力的变化态势一致,淡水资源消费的生态压力较小;(3)水环境账户中,水环境生态压力主要来源于氮污染,2000—2010年消纳污染的水生态占用变化不大,2011—2014年波动较大,历年生活水污染账户值均大于工业,今后要注重加强生活水污染防治,消纳污染的水生态承载力呈波动变化的趋势,水环境处于生态赤字状态,且其生态压力较高;(4)与现有生态足迹模型的比较分析可知:该模型核算更为全面;不考虑均衡因子,并以最大水生态压力指数来评价区域水生态系统所承受的压力状态具有合理性,更能准确反映贵州水生态的实际情况和水生态文明建设的需要.